MARVEL Scientific MPRO30iMT - Manuel (Page 14)

NOTE
NOTE
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Model W H
30iMT
145/8”
(37.1cm)
305/16”
(77.0cm)
30iMAT
145/8”
(37.1cm)
2711/16”
(70.3cm)
For overlay with lock option panel
thickness to be 3/4” (19mm) maxi-
mum to 5/8” (16mm) minimum.
Weight of the overlay panel
should not exceed 20 pounds (9.1
kilograms).
For the door to work properly
it is necessary to maintain a
minimum space of 9/32” (7mm) between the door and cabinet
flange as shown . This space can be adjusted by adjusting the
top and bottom hinge adapters.
H
W
Figure 11
Table A
Front of
overlay
panel
Step 5: Drill hinge clearance holes in overlay panel
Set the overlay panel on the door front, align the edges, and
clamp together. Clamp the panel firmly but be careful not to
damage the door or the panel. Mark center of hinge adapter
hole on wood panel, top and bottom. (See Figure 12.) Remove
wood panel from door and drill 5/16” (8mm) diameter clearance
holes into the overlay panels 3/4” (20mm) deep. These will be
clearance holes for the top and bottom hinge pins.
This is also a convenient time to locate and drill the holes for
your handle. Most often the handle is to match that of the sur-
rounding cabinetry. If your handle attaches from the back-side
of the custom panel, locate the mounting holes while the panel
Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabinet
prior to fabricating the custom panel. Failure to do so may
result in mis-alignment of the custom panel with the hinge
bracket. The door should be parallel to the sides and top of
the ice machine. If alignment is necessary the door may be
adjusted by loosening the 2 screws which secure the top and/
or bottom hinge adapter brackets, located on the top and
bottom of the door and adjusting the door side to side. Use a
5/32” allen wrench, for this procedure. (See Figure 10 below).
When finished aligning the door, tighten the screws securely.
Remove top hinge
pin to remove the
door.
Door should be
parallel to top
and sides of ice
machine.
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8” allen
wrench. Remove the door by angling the top of the door out-
ward and lifting the door off the bottom hinge.
(See detail in Figure 10).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To gain
access to the screw mounting holes remove the door gasket by
peeling up and out of the channel.
Step 4: Cut overlay panel
Depending on the ice machine model cut the overlay panel to
the dimensions shown in Figure 11 and Table A.
Figure 10
Hinge adapter bracket lo-
cated on the top and bottom
of the door.
9/32”
(7mm)
14