Garland THE SUMMIT ELECTRIC CONVECTION OVEN - Manuel (Page 10)

Part # 1955204 Rev 2 (07/13/12) Page 10
and light its LED.
Pressing the FAN LOW will activate the higher fan speed and
light its LED.
Pressing the FAN PULSE key the fan will be active the lower
fan speed and light its LED. The fan will be activated for 30
seconds then off for 30 seconds, and continues this cycle.
Pressing the SETBACK key will cool the oven cavity to
a preprogrammed temperature, see: Setting “Set-Back”
Feature. The oven will automatically go into Setback mode
after the pre-programmed non-usage time. The display will
indicate “SETB”. This is an energy-saving feature.
Pressing the COOL DOWN key will deactivate the heat, turn
the fan on high and light its LED. This display will indicate
“OPEN DOOR” if the door is closed, prompting the user
to open the door slightly. With the door open slightly the
display will indicate “COOL”. The Cool down will operate
when the door is closed or opened slightly. Optimal cool-
down will be achieved with the door open slightly. When
the door opens wider, the Cool Down mode will deactivate
and the display will indicate “DOOR”. This is a patented safety
feature. Pressing the COOL DOWN key again will turn the LED
off and stop this mode. Pressing the ON/OFF key will also
cancel Cool down. Cool Down is not active during a cook.
When the ON/OFF switch is pressed to turn the oven off and
the oven is above 200°F (93°C), the oven will go into an AUTO
COOL DOWN mode. In Auto cool Down, the oven will run the
fan on high until the oven cavity drops below 150°F (66°C).
During this time the display will indicate “AUTO”. When the
oven temperature drops below 150°F (66°C) the oven turns
off. This feature protects the oven motor from premature
failure. Optimal cool-down will be achieved with door open
slightly .
Fahrenheit/Celsius
Factory default is Fahrenheit (F). To change to Celsius (C),
press and hold in the “Phantom Key” located to the right of
“Cook/Hold” key. “F” appears in the display. Continue to hold
until “C” is displayed and then release the “Phantom key”
Operating the Controls
Setting the cook temperature and time are done in the same
manner. Pressing the SET key will light the TEMP LED. The
operator then sets the temperature by rotating the dial on
the controller until the desired temperature is shown on the
display. Pressing the SET key a second time lights the TIME
LED and allows the operator to select the desired cook time
OPERATING INSTRUCTIONS Continued