Garland ED SERIES ELECTRIC COUNTER UNITS - Manuel (Page 7)

Part # 4521653 Rev 1 (03/05/13) Page 7
INDIVIDUAL MODEL INSTALLATIONS
Hot Plate – Model ED-15H
Wall Clearances
Do not install appliance closer to a wall of combustible
material than:
Back 1 ½” (38mm)
Sides 1 ½” (38mm)
Supply Connection
For supply connection, use wire suitable for 90°C (194°F).
Electrical Connection
A knockout is provided near the front left side of the unit
located behind the control panel. To view knockout, loosen
the two acorn nuts and hinge control panel downward. The
terminal block is also located in this area.
The supply cable entrance is located on the right side when
facing the rear of the unit. The cable is fed towards the front
through a wire way.
Controls
Infinite switches are used to control the tubular elements:
HI to 5 - High Heat
5 to 3 - Medium Heat
3 to LO - Low Heat
Setting of switches between the numbers will give
intermediate heat. Switches are reversible and may be
turned right or left.
Solid Elements Hot Plate –
Model ED-15HSE / ED-15THSE
Wall Clearances
Do not install appliance closer to a wall of combustible
material than:
Back 1 ½” (38mm)
Sides 1 ½” (38mm)
Supply Connection
For supply connection, use wire suitable for 75°C (167°F).
NOTE: - All 208V 1 phase 60 hZ ED-15THSE models are
equipped with a 4-ft (1219mm) power cord and
NEMA L6-30P plug (HUBBELL HBL2621 or equivalent).
Electrical Connection
A knockout is provided near the front left side of the unit
located behind the control panel. To view knockout, loosen
the two acorn nuts and hinge control panel downward. The
terminal block is also located in this area.
The supply cable entrance is located on the right side when
facing the rear of the unit. The cable is fed towards the front
through a wire way.
Controls
Solid element hot plates are controlled by a six heat switch.
There are three boiling and three simmering positions. Turn
the switch left or right from the off position to the desired
number, one being the lowest setting and six being the
highest.
SWITCH
POSITION
WATTAGE
HEAT
15HSE 15THSE
1 240 200
Low (Simmer)
2 340 305
3 450 450
Medium
4 1300 950
5 1750 1400
High (Boil)
6 2600 2000
This hot plate is protected against overheating when running
empty or when using poor quality cookware, by a unique
built-in bimetal protector switch.
This protector cuts down the power automatically under the
above conditions, overriding the regular switch and it resets
itself when conditions return to normal. This is an important
safety feature.
Before Operating The Hot Plate
The top working surface has a heat resistant coating. Before
using the sealed hot plates for the first time, they should
be heated for a short period without a pan to harden and
burn off the protective coating (3-5 minutes at the highest
setting).
Sealed Hot Plates
All purpose sealed top elements provide an ease-clean top.
They are intended for boiling, simmering, sauté and other
top cooking.