Garland ED SERIES ELECTRIC COUNTER UNITS - Manuel (Page 6)

Part # 4521653 Rev 1 (03/05/13) Page 6
4. Secure unit to counter top through the holes located on
the underside of the appliance using 10A sheet metal
screws.
5. Smooth the silicone seal into the crevice with finger or
tool to provide a cove seal.
COUNTER TOP
SILICONE SEALANT
Installation Of Counter Stands (Optional)
1. Assemble and level counter stand as illustrated in the
instructions found in the counter stand carton.
2. Remove and discard leveling bolts on unit to be installed
on counter stand.
3. Place units in desired position on counter stand, securing
the first unit with 8-32 machine screws and flat washers.
Insert 8-32 machine screws through the 7/32” (5mm)
diameter holes in stand into the nutserts in the bottom of
ED Series unit.
4. Connect banking plates as described in section titled,
Installation of Banking Plates.
GENERAL INSTALLATION continued
5. Secure last unit to counter stand with 8-32 machine
screws and flat washers. Inserts 8-32 machine screws
through the 7/32” (5mm) diameter holes in stand into the
nutserts in the bottom of ED series unit.
Leg Installation
The leg channel is located on the package base. This channel
must be installed when using the legs.
BOTTOM OF UNIT
LEG CHANNEL
(QTY 2)
4" [102mm]
ADJUSTABLE LEG
(QTY 4)
LEG INSTALLATION