Whirlpool XHPC155XG - Manuel (Page 2)

2
toolS and PaRtS
Gather the required tools and parts before starting installation.
tools needed:
Utility knife 1/4" hex-head ratchet
or open-end wrench
Level
9/16" open-end wrench
Pliers or slip-joint pliers Bucket
INSTALLATION REQUIREMENTS
loCatIon RequIRementS
note: If the washer/dryer and pedestal assembly are located in
a garage, 3" (76 mm) must be added under the pedestal so that
the washer/dryer is 18" (458 mm) above the garage floor.
Towel Sponge
Parts Supplied:
Four #12 x 3/4" hex-head Drawer divider
sheet metal screws
additional Items needed:
1/4" nut driver 5/16" hex-head ratchet
or nut driver