NaceCare Solutions TTB1120 - Manuel (Page 10)

10
Machine Set-Up
AlWAyS ENSURE THAT THE bATTERy IS DISCONNECTED bEFORE MAKING ANy ADJUSTMENTS.
Fitting the brushes
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
The Pad is retained using Numatic’s own Padloc system (ask your supplier for details).
Only use manufacturer supplied brushes / pads.
TTB 1117 requires a 450mm brush or a 400mm pad.
TTB 1120 requires a 550mm brush or a 500mm pad.
Fitting and lowering the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor-tool gets snagged, whilst in transit.
Raise the floor-tool for transit or
lower for cleaning operation using
the lifting handle fitted to the back
of the machine (Fig.20).
We are now ready to set the
controls to suit the cleaning
conditions.
Before any settings can be
applied, ensure the brush deck is
lowered.
Safety gloves are recommended for the changing of used brushes.
Note:
It is easier to fit the floor-tool if the weight of the machine
is resting on the brush.
Ensure the brush is fitted first.
Machine Set-Up
Fit the brush /pad to the drive chuck,
twist to lock the brush
(Fig.14) / pad in place (Fig.15).
Tipping the brush Deck
To tip the deck into the down position
(Operating mode) press in the brush
deck locking bar (Fig.16) and rotate the
brush deck (Fig.17).
To change to brush deck up position,
(Transit mode) simply lift the deck and
the sprung loaded locking bar will
activate to hold the deck up.
Fig.15
Fig.17
Fig.20
Fig.19
Fig.18
Fig.16
Fig.14
Fit the floor-tool and retain using
the detent pin (Fig.18).
The lifting strap is held by a
detent pin (Fig.19).