Napoleon Fireplaces Castlemore GDS26 - Manuel (Page 36)

36
W415-0827 / D / 08.10.12
7.0 OPTIONAL BLOWER INSTALLATION
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and
grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian
Electrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.
A. Break out the blower and thermal switch knock-outs from the rear panel.
B. Fish the wire extension through the blower knock-out as shown and connect to the prongs on the thermal
switch.
C. Ensure the thermal switch is touching the wall of the fi rebox. Secure the
thermal switch assembly to the rear panel using 4 of # 8 screws supplied.
D. Connect the variable speed switch to the jumper wire (installed in the
appliance) located just inside the larger knock out area.
E. Insert the blower assembly into the rear panel and secure using the
remaining #8 screws supplied.
F. Remove the switch housing, connect the variable speed switch to the jumper
wire and mount the switch to the side of the housing. Attach and secure the variable speed switch using
the nut provided. Reinstall the switch housing. Install the variable speed switch knob.
WHITE
RED
BLACK
GREEN
(GROUND)
THERMAL SWITCH VARIABLE SPEED SWITCH
BLOWER
WIRE
EXTENSION
WIRE
HARNESS
(included in GS67 kit)
BLACK
TO
POWER
SUPPLY
LOCATED
IN WIRE
HOUSING
JUMPER WIRE (installed in fireplace)
GS67 WIRING DIAGRAM
VARIABLE
SPEED
SWITCH
KNOB
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
VOID THE WARRANTY AND CERTIFICATION.
ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
CONTACT WITH MOVING OR HOT OBJECTS.
51.5
BLOWER
ASSEMBLY
THERMAL
SWITCH
ASSEMBLY
GROUND
SCREW
SWITCH
HOUSING
VARIABLE
SPEED
SWITCH
LOCATION
THERMAL SWITCH
KNOCK-OUT
BLOWER
KNOCK-OUT