STEINEL RM 50 - Manuel (Page 8)

Troubleshooting
M-14201-1
Wireless communication troubleshooting
• Are the products you wish to connect set to the same group address?
• Is the receiver device too far away from the transmitting device, resulting in too weak of a signal at
the receiver? (See Transmission Range on page 3.)
• Can the radio signal leave the transmitter and reach the receiver or is it inhibited by interference
(metal enclosure etc)?
• Is there any possible interference from other transmitters operating on the same frequency?
• Are any other transmitters operating outside the system which, although working on a different
frequency, are doing so at very high transmission power (ham radio etc.)?
RHB 300, RHB 200 sensor troubleshooting
No power at the
sensor
Lights do not switch
ON
Lights do not switch
OFF
Lights keep
switching ON/OFF
Lights switch ON
without obvious
movement
breaker has tripped; light switch is in
OFF position
short circuit
light level setting is in nighttime
mode during daytime operation
lamp burned out
power is off
detection zone not correctly adjusted
abundant heat from the fi xture is
within detection zone and keeps
lights on as a result of temperature
change
the fi xture is moving from side to side
HVAC vent is causing air fl ow to
switch lights on
reset breaker, turn light switch
to ON position, check wiring
with voltage tester
check for proper wiring
connections
adjust light level setting
replace lamp
turn power on at circuit breaker
readjust
readjust zone or apply shroud
stabilize the fi xture
redirect air fl ow away from the
sensor
Malfunction Cause Remedy
Warranty
STEINEL America warrants its products against
defects in material or workmanship for a period
of fi ve years. STEINEL will replace or repair
the item provided that it has not been altered
or subjected to abuse, accident, improper
installation or improper use. There are no
obligations or liabilities on the part of STEINEL
for consequential damages arising out of or in connection with the use or performance of this
product or other indirect damages with respect
to loss of property, revenue, or profi t, or cost of
removal, installation or reinstallation.
The RHB 300, RHB 200 and RM 50 contain the
MF1-UL Wireless Control Module.
FCC ID - W8J7060
IC - 8529A-7060
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
conditions:
(1) this device may not cause harmful
interference
(2) this device must accept any interference
received including interference that may cause
undesired operation
(3) Changes or modifi cations not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment
www.steinel.net (800) 852-4343 www.steinel.net (800) 852-4343
14 15