Electrolux EDC78550W - Manuel (Page 17)

• Energy consumption (corrected with final
humidity) during the cupboard dry cotton
cycle with half load.
• Final humidity (during cupboard dry cot-
ton, iron dry cotton and cupboard dry
easy care)
• Condensation efficiency (corrected with fi-
nal humidity) during cupboard dry cotton
cycle with nominal and half load
All the cycles have to be checked in accord-
ance with EN 61121 (Tumble dryers for
household use – Methods for measuring
the performance).
INSTALLATION
Important! The appliance must be moved
in vertical position for transport.
Appliance positioning
• It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the air intake
grilles at the back of the machine.
• To keep vibration and noise to a mini-
mum when the dryer is in use, it should
be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level
with the aid of a spirit level. If it is not,
raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deep-
pile carpets, strips of wood or similar.
This might cause heat built-up which
would interfere with the operation of the
appliance.
Important!
The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The ap-
pliance must therefore not be installed on
floors which are not resistant to high temper-
atures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Important! Should the appliance be
moved, it must be transported vertically.
Important! The appliance must not be
installed behind the lockable door, a sliding
door a door with a hinge on the opposite
side to that of the appliance.
Removing transport safety packaging
Caution!
Before use all parts of the transport packag-
ing must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
electrolux 17