Electrolux EUF2947GOX - Manuel (Page 14)

Problem Possible cause Solution
The compressor operates
continually.
Temperature is set incor-
rectly.
Refer to "Operation" chap-
ter.
Many food products to be
frozen were put in at the
same time.
Wait some hours and then
check the temperature
again.
The room temperature is
too high.
Refer to climate class chart
on the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool
to room temperature before
storing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water
outlet to the evaporative
tray.
There is no ice production. The ice maker is not switch-
ed on.
Refer to "Switching on and
off the ice maker".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Door is misaligned or inter-
feres with ventilation grill.
The appliance is not level-
led.
Refer to "Levelling".
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The food products' temper-
ature is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
The door has been opened
often.
Open the door only if nec-
essary.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
E1 is flashing the tempera-
ture display.
No water supply. Carry out the necessary
measures on the water sup-
ply. Press any button to re-
set the Alarm.
www.electrolux.com 14