CAMPO EQUIPMENT BLAZE 600 D - Manuel (Page 6)

CAMPO EQUIPMENT CO. LTD. (ECOBLAZE)
6 Carson Court, Brampton, ON, CANADA, L6T 4P8
Tel: (905) 793-2525 | Fax: (905) 793-8768 | www.campoequipment.com
CONNECTING TO
AN
EXTERNAL FUEL TANK
(BLAZE 600 D)
Beckett CF800 is fitted with 3/8” SAE male
fittings and is set up for a 2 line system to eliminate
priming. Ensure fuel tank has an supply line and a
return line and connect the supply line to the 3/8”
SAE fitting on the inlet side of the fuel filter and
the return line to the return fitting located on
the Beckett Burner pump. For a 1 line system
remove bypass plug located on inlet port of Beckett Pump and just connect fuel line to inlet side of
fuel filter.
ELECTRICAL
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS ABLE IS TO RECEIVE 1 PHASE
120V SUPPLY MUST BE AVAILABLE.
INSTALLATION
10/3 upto 100ft
NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE
REPLACED, IT MUST BE REPLACED WITH TYPE TEW 14GA WIRE OR ITS EQUIVALENT.
ELECTRICAL SYSTEM BLAZE
600 D
Volts-Hertz-Phase 120-60-1
Full Load (Amps) (1PH) 17
Max fuse size (Amps) (1PH)
with time delay 20
The electrical grounding of the heater shall be in compliance with the National Electrical Code, ANSI/NFPA
70, or the CSA C22.1, Canadian Electrical Code, Part I
Head Setting
1
Air Setting (Beckett-
Shutter/Band))
3/0
APPROVAL AGENCY
OMNI
DRY WEIGHT (lbs)
700
Dimensions
70" X 26" X 61"
FLUE SIZE 6”