Danze D469700 - Installation Manual - Manuel

• Installation Steps:
• Hardware Provided/Petit matériel de fixation fourni/Se incluye los herrajes:
Mounting Screw/Vis de fixation/Tornillo de montaje
Plastic Anchor/Vis d'ancrage en plastique/Sujetador de plástico
Hex wrench/Clé hexagonale/Llave hexagonal
Versa™ 30" Slide Bar
Barra Versa™ de 30"
Barre coulissante Versa
MC de 30 po (76 cm)
I N S T A L L A T I O N
Fig 2
Fig 1
Fig 3
This product is packaged partially assembled. You will need to take some
components apart to install.
INSTALL TOP SLIDE BAR POST
1. Remove cap. Using hex wrench (supplied), loosen set screw and
remove post from slide bar base (Fig 1).
2. Locate where you want to install the slide bar. Use the top post as a
template and mark locations on shower wall using pencil (Fig 2).
3. Using the drill bit, carefully drill four holes.
TIP: INSTALL ONE POST, THEN ASSEMBLE SLIDE BAR AND CONFIRM
HOLE POSITION OF SECOND POST BEFORE DRILLING (Fig 3).
4. Insert the plastic wall anchors into the four holes. You may need to tap
them lightly into position with a hammer (Fig 4).
5. Secure post with mounting screws provided (Fig 5).
6. Place and hold the slide bar with slide body onto the post; it should "click"
into place. Tighten the set screw with supplied hex wrench, then press the
cap (Fig 6).
NOTE: When installed correctly, the slide body will have screw holes located
on the bottom side. See Fig 6.
7. Repeat step 5-6 for bottom of slide bar (Fig 7).
Post/
montante/
fixation
Slide bar/
Barra/
Barre coulissante
Base/Base/Base
Cap/
Tapón/Capuchon
Slide body/
Pieza deslizante/
Support coulissant
Drill bit/Barrena/Foret
Drill/Taladro/Perceuse
• Tools Required/Outils requis/Herramientas necesarias:
Flathead Screwdriver/Tournevis á lame plate/Destornillador chato
Phillips Screwdriver/Tournevis Phillips/Destornillador cruciforme
Marking Pencil/Marqueur/Lápiz marcador
Level/Niveau/Nivel
Drill/Perceuse/Taladro
¼” Drill Bit/Barrena de ¼”/Foret de ¼ po (0,6 cm)
• Pasos para la instalación:
Este producto está parcialmente ensamblado. La instalación requiere el
desemsamblaje de algunos componentes.
D469700