Faber AXIA ISOLA - Manuel (Page 7)

Version 02/02 - Page 7
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel, located on top of the rangehood canopy.
The position and function of each control button are indicated
in FIGURE 15.
FIGURE 15
FIGURE 16
WARRANTY & SERVICE
This rangehood carries a limited warranty against manufac-
turer's defects. To obtain warranty service, contact the dealer
from whom you purchased the rangehood, or the local Faber
distributor. If you cannot identify a local Faber distributor,
contact Faber USA at (508) 358-5353 for the name of a
distributor in your area.
• This rangehood uses 20 watt halogen lamps.
Replacing the Lamps
Before attempting to replace the lamps ,make sure that the
light switch is turned off. To replace the lamp, the bezel (A)
around the lamp(C) must be removed as indicated in FIGURE
16. This bezel (A) is held in place by two screws (B). Remove
the two screws and the bezel. Then remove the lamp and
replace with a new lamp. Once the new lamp is in place,
reinstall the bezel.
Light On/Off Button ( L )
On/Off switch for the halogen light. Move the switch to "1"
to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn
the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Variable speed control for blower. Move the switch to the far
left for LOW Speed and to the far right for HIGH speed.
For Best Results
Start the rangehood before cooking and allow the unit to
operate for several minutes after cooking is complete to clear
all smoke and odors from the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot
detergent solution or washed in the dishwasher. Stainless steel
cleaner should be used on stainless rangehoods. Abrasives
and scouring agents can scratch stainless steel finishes and
should not be used to clean finished surfaces.
WIRING DIAGRAM