Homelite HHC35A - Manuel (Page 17)

17
100577
13. Perform steps 1 through 6
(see page 16).
14. Place fine grade sandpaper
(600 grit) on flat surface.
Sand rotor lightly in “Figure
8” motion four times (see
Figure 30).
15. Reinstall insert and rotor.
16. Perform steps 10 through 12
(see page 16).
Gap Adjusting Screw
.003"/.004" (.076-.101 mm)
Gap Measured With
Feeler Gauge
Gap Adjusting Screw
Rotor
Blade
Figure 29 - Gap Adjusting Screw Locations
Model Size 35 100 150
Output Rating (Btu/Hr) 35,000 98,000 150,000
Fuel Use Only Kerosene or No. 1 Fuel Oil
Fuel Tank Capacity (U.S. Gal./Liters) 3/11.3 9/34 13.5/51
Fuel Consumption (Gal. Per Hr/
Liters Per Hr)
.26/.98 .74/2.80 1.12/4.24
Nozzle Spray Angle 50° 60° 60°
Nozzle Spray Pattern Solid Cone (All Models)
Electric Requirements 120 V/60 HZ (Same All Models)
Amperage (Normal Run) 1.7 3.2 4.4
Motor RPM 1725 3450 3450
Hot Air Output (CFM) 165 481 500
SPECIFICATIONS
Figure 30 - Sanding Rotor
Sandpaper