Electrolux 96901K - Manuel (Page 18)

18
Using the automatic warm-up function
Switching on the automatic warm-up function
The duration of the warm-up phase depends on the heat setting selected.
Set the required heat setting ( to ) via the “heat setting selection” sensor field .
The set power level lights up in the digital display.
lights up in the digital display after approx. five seconds.
The automatic warm-up function is activated.
After the end of the warm-up time, the heat setting selected will be shown again.
Switching off the automatic warm-up function
Only an activated automatic warm-up function may be switched off.
Touch the „heat setting selection“ sensor field.
The heat setting selected lights up in the digital display.
The automatic warm-up function is switched off.
Do not use the automatic warm-up function
In the event of residual heat being present the automatic warm-up function will
not be activated for this cooking zone.
When the automatic warm-up function is active select a higher heat setting, e.g.
instead of , the warm-up time will be automatically adjusted to the selected heat
setting.
If you select a lower heat setting the automatic warm-up function will be switched
off immediately.