English – Pit Boss 50 Portable Gas Griddle Owners Guide Manuel d'utilisation

Page 10

Advertising
background image

ENGLISH

10

MANUAL LIGHTING PROCEDURE

1. Open lid during lighting.
2. Set all control knobs to the “O” position.
3. Open the cylinder/gas valve according to the operating

instructions on tank.

4. Quickly and carefully, use a lit match secured with the lighting

rod (included with the grill) to light the burner. Gain access

to the burner from beneath the Hot Plate. Position lit match

near the side of the burner.

CAUTION: Do not attempt to light another area of the

burner. This can cause injury.

5. Push and turn the burner control knob counter-clockwise to

“ (light position)“, hold this knob in for 10 seconds after the

burner is lit. You will hear the “snapping” sound of the spark

until after the knob is released.

NOTE: Do not use spirit, lighter-fluid or kerosene for

lighting or refreshing a fire in your griddle.

6. If the burner does not light within 5 seconds, turn burner control knob to “O”, wait 5 minutes, and repeat lighting instruction.

After lighting, observe the burner flame. Make sure all burner ports are lit and flame height matches illustration shown

previously.

NOTE: Each burner lights independently - repeat same steps for other burners.

WARNING: Never lean over the cooking area while lighting your gas grill. Keep your face and body a safe

distance (at least 457 mm / 18 inches) from the cooking grid surface when lighting your grill by match.

7. If the above points do not work, see

Troubleshooting.

SHUTTING OFF YOUR GRIDDLE

1. When finished cooking, turn gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This safety

feature locks the regulator knob to ensure that the gas is no longer flowing.

2. Turn control knobs to the “O” position.

NOTE: A “poof” sound is normal as the last of the LP gas is burned.

3. Disconnect gas supply by following the

Disconnect A Gas Cylinder

instructions.

WARNING: Allow the griddle to cool completely, and remove the gas cylinder, before moving, travel, or for

storage.

Advertising