Pit Boss 23 Inch Portable Tabletop Gas Grill Owners Guide - Manuel (Page 9)

ENG
LISH
9
INSTALLING A GAS CYLINDER
1. Ensure the regulator valve on the grill is completely closed by turning the knob
clockwise to the OFF position.
2. Remove the protective caps from the regulator valve opening and the top of the gas
cylinder. Save the caps.
3. Insert the 1 lb. gas cylinder into the threaded opening of the regulator valve. Turn
the cylinder clockwise until firmly seated. Hand-tighten only.
4. For optimum performance, allow cylinder to hang vertically off the edge of the table
or sits stable on a table (clean, level surface) where there is no danger of being
bumped or disturbed. Note proper positioning shown below:
WARNING: Do not fold up or transport grill with gas cylinder
attached. The cylinder may loosen off the valve, and cause a gas
leak, possibly resulting in an explosion, fire, or severe bodily harm.
Disconnect gas cylinder first before travel or storage.
DISCONNECTING A GAS CYLINDER
1. Ensure the regulator valve on the grill is completely closed by turning the knob
clockwise to the OFF position.
2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator
valve opening. Replace the protective caps on the regulator valve opening and the
top of the gas cylinder for storage (if not empty).
NOTE: If storing the grill indoors, leave the gas cylinder outdoors.