Airpulse A300 Bluetooth Speaker System (Pair) - Manuel (Page 5)

Install or replace remote control battery
1. As the illustration shows, with thumb press down the slot of battery cover and slide
to remove the cover
2. Place the two AAA batteries (note the “+” and “-”pole) into the remote control and
close the battery cover.
Installing Battery in Remote Control
1. The battery life is normally about 6 months; please replace it when the remote
control is not sensitive or the control distance to be shortened.
2. Remove the battery immediately when exhausted to avoid explosion or acid leaks.
3. Discard the battery immediately in the event of battery leakage, paying attention
not to touch the leaking materials.
If leaking is in contact with skin or gets in eyes/mouth, rinse immediately and seek
emergency treatment immediately. Please clean the battery compartment thoroughly
prior to installing new battery.
4. Never use the remote control in conditions below:
–Places with high humidity, e.g. a bathroom
–Places with high temperature, e.g. near a heater or stove
–Places with extremely low temperature
–In dusty places
5. Never swallow the batteries in case of chemical burning risk.
6. Never mix old and new batteries. This will shorten new battery life or cause old
battery leakage.
7. Remove the battery when unused for a long period of time to avoid battery leakage.
8. Never use this product when battery compartment is not securely closed, and keep
the remote control away from children. Never let children touch the battery.
9. If the battery is accidentally swallowed, rush to hospital immediately.
10. Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent
11. The battery should not be exposed to excessive heat such as direct sun, fire or similar.
Remote Control Illustration
Aim remote control at the remote control receiving window
The optimum operational distance is within 7 meters.
When the system receives remote control commands, display
value of display window will alert or flash.
② Mute
④ Play/Pause
⑤
②
③
④
①
⑥
⑤
⑦
⑧
⑨
10
11
USB input mode
Bluetooth input mode
Optical input mode
Coaxial input mode
AUX input mode
Balanced input mode
(Bluetooth)
USB
⑥ OPT
Volume control buttons
Mute off speaker output
③ Volume up/down Adjust playing volume
Playback selection buttons
Input source selection buttons
⑦ COAX
⑧ AUX
⑨ BAL
10
11
How to operate remote control
30 30
Within 7 meters
Previous/next track in
Bluetooth/USB mode
Audio source play/pause
in Bluetooth/USB mode
7 8
AUX BAL
USB
OPT COAX
AUX BAL USB
OPT COAX
Note
①
Previous/
Next track
* When playing music in Bluetooth mode and switching to other modes, Bluetooth
connection will automatically return if selecting Bluetooth mode again.
* When playing music in USB mode and switching to other modes, PC needs to be
reset for USB mode to be selected again.
Please refer to “Set this product as the audio output device of PC” .
English English
O
Standby button
When powered on, press the “ ” button to let the
speaker enter standby mode. Displayed value of remote
control receiving window on the active speaker will
disappear but internal power is still being connected.
Re-press the “ ” button or press the “VOLUME/INPUT”
knob on the rear panel of the active speaker to power
on the speaker again.
Press the “ ” button on the rear panel to turn on/off
the main power.