Danby DPAC 12099 - Manuel (Page 9)

Control Buttons:
1) Power Switch
2) Mode
3) Fan Speed
4) On / Off Timer
5) Time / Temperature Set
• Used for adjusting the timer and temperature.
• The default display on control panel is room temperature.
• When
key is pressed in cool mode, the set
temperature is displayed and may be adjusted. After 10 seconds the
display will revert back to room temperature.
• Timer setting is available from 1-24 hours by pressing the
key
To operate the hand held remote control you will require two “AAA”
Alkaline batteries (included).
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to program the main unit.
b) The main unit does not respond to a command issued by the remote
control.
Battery replacement:
1) Slide the rear cover on the remote in the direction of the arrow.
Continue pulling (gently) until the cover separates completely from the
unit.
Notes:
1) Do not drop the remote control.
2) Do not place the remote control in a location exposed to direct sunlight.
3) The remote control should be placed about 1 meter or more away from TV, or any electrical appliances.
This Class B digital apparatus complies with canadian ICES-003.
The functions work the same as your dehumidifier’s touch controls.
Batteries: Remove the cover on the back of the remote control and insert the batteries with the (+) and (-)
poles pointing in the proper direction.
CAUTION: Use only AAA or IEC R03 1.5 V batteries.
• Remove the batteries if the remote control is not used for a month or longer.
• Do not attempt to recharge the supplied batteries.
• All batteries should be replaced at the same time.
• Do not dispose of batteries in a fire as they may explode.
PLACING BATTERIES
IN REMOTE COTROL
REMOTE CONTROL FEATURES
8
2) Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery chamber (+ / -).
3) Re-install rear cover.
4) If the remote control will not be used for extended periods of time (vacations, etc.),
batteries should be removed.
The remote operates within a range of 8 meters (26 ft.) from the receiver located inside the main unit. Any
obstruction between the receiver and remote may cause signal interference, limiting the ability to program the
unit.