Danby DWM5500W - Manuel (Page 6)

INSTRUCTIONS FOR USE
Instructions for Use 5
Important
Before putting the machine into use, don't
forget to remove the transport brackets.
Switching on a blocked machine may damage
the machine. Our guarantee does not cover
such damage.
• Before switching the machine on, check that
the transport brackets have been removed.
• Don't place the appliance in a room where the
temperature may fall bellow 32°F, causing
individual parts of the machine to freeze and
become damaged (hose may crack).
• The appliance should stand firmly and
horizontally on a solid base (a machine
standing on an uneven floor is very likely to
vibrate during the spinning cycle).
• Always consider the instructions for correct
placing and installation of the machine to the
mains and water supply. This will help you
avoid accidents and protect your machine
against damage.
• The end of the outlet hose should not be
immersed in the discharge water (the machine
may pump the discharge water back).
• During the washing cycle, the door of the
machine cannot be opened. It can only be
opened 2 minutes after washing is finished.
• The glass door gets very hot during washing,
so take care of children.
• Use only washing powder and other agents
specially designed for machine washing.
We do not take any responsibility for damage
caused by the improper use of bleaching or
coloring agents (colored gasket and other
plastic parts).
• Lime dissolving agents contain acid, so only
use those containing rust-protection agents.
Always consider the manufacturer's
instructions. When you have finished removing
lime deposit, run a few rinse cycles to make
sure that the acid is thoroughly rinsed. Even
traces of acid can cause substantial damage to
component parts.
• Never use washing agents containing solvents
- individual component parts may be damaged
or toxic gases may be produced. There is also
a risk of ignition or explosion.
• When washing is finished, remember to close
the tap.
• Your washing machine can only be transported
with transport brackets. It is usually enough to
use only one of the rods, that is the upper one.
It is much easier to insert the rod if you remove
the top cover. Before doing anything, however,
don't forget to disconnect the machine from the
power supply.
• Data plate with essential information on the
appliance is fitted above the opening for
laundry insertion under the door frame.
(UKS) - Unbalance Control System
This washing machine is equipped with the UKS
- unbalanced control system. This means that the
spinning starts smoothly, even in case of smaller
wash loads or inadequate loads.
In case of unfavorable distribution of laundry in
the drum, this is sensed by the UKS system and
the automatic re-distribution of the laundry
follows immediately, then only spinning starts.
In case the re-distribution of the laundry is not
successful (only one large piece in the drum), the
UKS system reduces the spinning speed (r.p.m.),
to prevent damages to the washing machine.