DCS WDI - Manuel (Page 8)

INSTALLATION INSTRUCTIONS
6
WDS-27
WDS-30
A
9-7/8” 25-5/16”
9-7/8” 25-5/16”
24” (min.)
24” (min.)
SPECIFICATIONS
The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall
should be at least 24” (see figure 02).
The Warming Drawer should be installed into a base cabinet with minimum outside dimensions of
13-1/4” high by 30” wide by 24” deep for 30” models. For 27” models 13-1/4” high by 27” wide by 24”
deep. For WDI Model 15-1/4” high by 26-3/4” wide by 24” deep (see figure 03 and figure 04).
Power supply required: 120VAC; 5A min., 15A max. circuit.
A
B
C
1-1/2" min.
to bottom of
countertop
A 120 volt AC
outlet should be
located below the
Warming Drawer
2x4's or similar
support
WDS - 10-1/4"
WDI - 11-7/8"
WDS-27 = 26-7/8"
WDS-30 = 29-7/8"
WDI = 26-3/4"
23-7/8 "
WDS-30 = 29-7/8"
WDI = 26-3/4"
25-1/16 "
28-3/16 "
POWER
CORD
9-7/8 "
24 "
POWER
CORD
9-7/8 "
1 "
11-1/4 "
B C
CUTOUT DIMENSIONS
Fig. 02
Fig. 03 Fig. 04
CUT OUT DIMENSIONS
WARMING DRAWER DIMENSIONS
(FRONT VIEW)
WDS-27 & WDS-30 DIMENSIONS
(SIDE VIEW)
WDI 11-1/4” 26-1/8” 24” (min.)
WDI