Paradigm Titan v4 Manuel d'utilisation
Page 3

FRONT, CENTER AND SURROUND SPEAKERS (cont’d)
Positioning Front Speakers (cont’d)
(including speakers with built-in powered subwoofers)
Bass Performance
If possible, position your speakers 20cm (8in) or more from
the wall behind the speakers. This will ensure better bass
performance. Ideally, the distance to the side walls should
be different from the distance to the back wall (Fig. 3).
Placing the speakers in corners may over - emphasize bass.
For more balanced bass, we recommend that you avoid
corner placement when positioning your speakers. (Fig. 4).
Positioning Center Speakers
Placing your Paradigm center speaker above the TV will
ensure the best possible clarity and intelligibility (Fig. 5).
Position the speaker flush with the front of the TV or speaker
shelf to minimize unwanted sound reflections.
Make sure your center speaker is approximately the same
distance away from the primary listening position as your
front speakers. (Some A/V receivers and processors can
electronically adjust for differences in distance.)
Positioning Surround Speakers
ADP surround speakers can be wall-mounted to the left
and right of the listening area, at approximately ear level or
higher, using the supplied hanger brackets (❶).
Alternatively, ADP surrounds can be placed at about ear -
level on Premier™ stands in the back corners of the room with
their drivers pointing at the converging walls (❷). They can
also be moved out from the corners and placed as close as
1m (3ft) from the listening position (❸).
To ensure a large reverberant soundfield, set up each speaker
with the “nameplate” grill pointed at the listening position.
Your ADP speakers may be marked left and right to help you set them up in a way that ensures optimal sound. If
they are, install the right speaker on your right side and the left speaker on your left. (The TV is considered the “front”
of the room.)
Direct-radiating surround speakers can be placed in position (❶) and (❷), as shown in the drawing above with
their drivers pointed at the listening position. For the best possible performance, keep direct-radiating surrounds
well back from the listening area.
3
❶
❷
❸
Fig.3
Fig.4
Fig.5
Fig.6
ENCEINTES AVANT, CENTRALE, ET D'AMBIOPHONIE (cont’d)
Position des enceintes avant (cont’d)
(y compris, les caissons de sous-graves amplifiés)
Performance de reproduction des graves
Si possible, positionner les enceintes à au moins 20 cm (8 po)
du mur placé derrière; on obtient ainsi la meilleure reproduction
des graves. Idéalement, les distances entre une enceinte et les
différents murs de la pièce devraient être différentes (fig. 3).
Pour rehausser les graves et susciter un effet de réverbération,
angler les enceinte. Pour obtenir une reproduction plus équilibrée
des graves, éviter de placer les haut-parleurs dans les coins de la
pièce (fig. 4).
Positionement de l'enceinte du canal central
On obtiendra un meilleur niveau de clarté et d'intelligibilité si
l'enceinte Paradigm du canal central est placée au dessus du
téléviseur (fig. 5). Pour minimiser les réflexions indésirables du
son, placer l"enceinte à égalité avec la surface avant du téléviseur ou
avec le bord de l'étagère.
Veiller à placer l'enceinte centrale approximativement à la même
distance du point d'écoute que les enceintes avant. (Certains
processeurs et récepteurs A/V peuvent effectuer électroniquement
une compensation de la différence entre ces distances)
.
Position des enceintes ambiophoniques
On peut installer les
enceintes ambiophoniques ADP sur les
murs, à gauche et à droite de la zone d'écoute et approximative-
ment au niveau de l'oreille ou plus haut, à l'aide des brides de
suspension fournies (❶).
On peut également installer les enceintes d'ambiophonie ADP
sur des supports Premier
MC
dans les coins arrière de la pièce,
approximativement au niveau de l'oreille, les éléments actifs
étant orientés vers les murs convergents (❷). On peut également
les écarter des angles pour les placer jusqu'à un minimum de
1 m (3 pi) de la position d'écoute (❸).
Pour avoir un champ de réverbération étendu, placer chaque enceinte en orientant la plaque signalétique vers la position d'écoute.
Il se peut que les enceintes ADP soient identifiés pour «côté gauche» et «côté droit»; le cas échéant, installer l’enceinte «droit»
sur le côté droit et l’enceint «gauche» sur le côté gauche (la position du téléviseur correspondant à l'avant de la pièce).
On peut placer
des enceintes d'ambiophonie à rayonnement direct aux positions (❶) et (❷), représentées sur le dessin
ci-dessus, les éléments actifs étant orientés vers la position d'écoute. Pour obtenir une performance optimale, placer ces
enceintes à bonne distance de la zone d'écoute.
3
❶
❷
❸
Fig.3
Fig.4
Fig.5
Fig.6
- Titan v3 Titan v2 Titan v1 Studio Monitor PW-2500 PW-2200 v2 PW-2200 PW-2100 v2 PS-800 PS-1200 v4 PS-1200 v3 PS-1200 PS-1000 v4 PS-1000 v3 PS-1000 Phantom v4 Phantom v3 Phantom v2 Phantom v1 9se-MkII 9se 7se-MkII 7se 5se-MkII 5se 3se 11se-MkII PDR-8 v3 PDR-8 v2 PDR-8 PDR-12 v3 PDR-12 PDR-10 v3 PDR-10 Micro v3 Micro v2 Micro v1 Legend v3 Legend v2 LCR-150 v1 Focus v4 Focus v3 Export Monitor Esprit v4 Esprit v3 Esprit Monitor Eclipse Monitor Compact Monitor CC-70-v3 CC-70-v2 CC-50-v1 CC-270-v4 CC-270-v3 CC-170-v4 CC-170-v3 CC-170-v2 CC-150-v1 Atom v4 Atom v3 Atom v2 Atom v1 ADP-70 v3 ADP-70 v2 ADP-170 v4 ADP-170 v3 ADP-170 v2 ADP-150 v1 ADP-100 v1 3se-mini