Danby DPA120HB1WDB - Manuel (Page 15)

Remove the
upper drain
plug
Continuous
drain hose
Installation Instructions
WATER DRAINAGE • During dehumidifying modes, remove the upper drain plug from the
back of the unit, install the drain connector (5/8” universal female con-
necter) with 3/4” hose (not included). For the models without a drain con-
nector, just attach the drain hose to the hole. Place the open end of the
hose directly over the drain area in your basement floor. Please refer to
Fig.22a.
During heating pump mode, remove the lower drain plug from the back of
the unit, install the drain connector(5/8 universal female connector) with
3/4 hose (not included). For the models without drain connector, just
attach the drain hose to the hole. Place the open end of the hose directly
over the drain area in your basement floor. Please refer to Fig.22b.
NOTE: Make sure the hose is secure so there are no leaks. Direct the
hose toward the drain,making sure that there are no kinks that will stop
the water from flowing. Place the end of the hose into the drain and make
sure the end of the hose is down to let the water flow smoothly. (See
Fig.22a, 22b). Never raise it. (See Fig.23a, 23b).
• When the water level of the bottom tray reaches a predetermined level,
the unit beeps 8 times, the digital display area shows P1. At this time
the air conditioning/dehumidification process will immediately stop.
However, the fan motor will continue to operate (this is normal).
Carefully move the unit to a drain location, remove the bottom drain plug
and let the water drain away (Fig.24). Restart the machine until the P1
symbol disappears. If the error repeats, call for service.
NOTE: When operating or draining water always protect carpeting or
floors from possible water spillage.
NOTE: Be sure to reinstall the bottom drain plug before using the unit.
Fig.22a
Fig.22b
Fig.24
14
Continuous
drain hose
Remove the
lower drain
plug
Drain hose
adaptor
Drain hose
adaptor
Fig.23a Fig.23b