Panasonic WV-CL834 - Manuel (Page 30)

8. Adjust the horizontal phase by pressing ^ or
. The adjustable range is 0 - 2.0ps.
9. Move the cursor to SC COARSE. The cursor starts
blinking.
10. Press d or to match the color (hue) of the
camera's video signal, when observed at the out­
put of the Special Effect Generator (SEG) or
Switcher, as closely as possible to the color of the
original scene. (SC COARSE adjustment can be
incremented in steps of 90 degrees (4 steps) by
pressing CJ or 0-.)
Note: After the fourth step, the adjustment returns
to the first step.
1 (1 -- 4): 0 degrees
i
2(1 - - 4); 90 degrees
i
3 (1 --4): 180 degrees
i
4 (1 - - 4): 270 degrees
11. Move the cursor to SC FINE. The cursor starts
blinking.
12. Press ^ or to match the color (hue) of the
camera’s video signal, when observed at the out­
put of the Special Effect Generator (SEG) or
Switcher, as closely as possible to the color of the
original scene.
The SC FINE adjustment has a range of 90
degrees of color shift.
Notes:
• When the T' cursor reaches the “+" end, it
jumps back to . At the same time, SC
COARSE is incremented by one step to
enable a continuous adjustment. Thé reverse
takes place when the 'T’ cursor reaches the
end.
• When ^ or is kept pressed for a second
or more, the “I” cursor moves quickly.
• For more accurate adjustment, supply both
the original camera video output signal and
the effect output video signal (program output
video signal) of the special effects generator
(SEG) to a vectorscope and compare the
chroma phase of both signals.
• To reset SC COARSE and SC FINE to the val­
ues preset at the factory, press ^ or
simultaneously. SC COARSE is reset to the
factory setting.
-28-