Panasonic CYVM1500EX - Manuel (Page 31)

Electrical Connections
Cautions:
•To prevent damage to the unit, be sure to follow the connection diagram below.
• Remove approx. 5 mm of protective covering from the ends of the leads before connecting.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis.
Bundle all cables and keep cable terminals free from touching any metai parts.
Cable wiring diagram
Basic system configuration
CX‘DV1500 (Rear)
Accessories for use
AUDIO VIDEO
Display Unit
(Be sure to install the display unit
at least 1 m away from the controller unit.)
I
No. Part Qty
О Connection cable 1
о
Power Connector 1
Power Connector
•I')
Yellow
If interference occurs
in AM radio reception,
connect this screw
to the vehicle chassis
metal.
White (L)
О Power Connector
Red (R)
RCA Cord
(sold separately)
Ф BATTERY LEAD
(Connect to the car battery)
Resistor (1 kn)
Output Lead
To the rear view camera.
Please consult your nearest
authorized professional
Input Lead installer for assistance.
Not Used
GROUND
(Connect to a dean, bare
metallic part of your vehicle.)
PARKING BRAKE
CONNECЛON LEAD
REMOTE CONTROL SIGNAL
RECEIVER CORD
POWER
(connect to the ACC power
source in the car)
Л___________
Red
Parking Brake Connection Lead
♦ (- Pago 34)
Accessory Power Source (ACC Power Source)
Input Lead (12V DC)
‘ —► To spots where the power source
Fuse (3 A) is cut when the engine key is removed.
Do not connect to spots which have
a constant power source.
Lay the wire so that it does not gel
tangled up with screws or the moving
parts of seat rail.
White (L)
White (L)
Red (R)
i Red(R)
(AUX-IN)
Black
AUX-IN
CONNECTOR
When connected to the lead colored
in dark blue of the Panasonic CD
receiver or cassette receiver having
a AUX-IN input terminal, instead ol
connecting to the ACC power source,
the power of unit can be linked to
that of receiver.
CO Changer
Control Connector
CQ-DF88EUC
CQ-DFX888LEN
CQ-DFX777EW
Black
Ground Lead
—¥■ To the vehicle chassis metal.
AIVTENNA
fi
Û
T
w
Power
Connector
Dark Blue
□ Connecting the power source
Notes:
• This monitor system is designed only for use with a 12 volt DC motor vehicle.
• Be sure to fully plug in the connector.
• Install the cord to avoid high-temperature spots and secure with clampers and tape.
• When game devices are connected, the image may be unstable.
• When removing the DIN plug, be sure to press the clip.
CY-VM1500EX
31