Panasonic PanaSync - Manuel (Page 20)

Power Management System J
This monitor conforms to the VESA DPMS standard.
This function can suppress power consumption by the display unit.
The computer and video board being used must also conform to the VESA DPMS standard.
Note; Regarding operation, please consult the Operation Manuals for the hardware being
used. Modes change in response to input signals as indicated in the table below.
АРМ state Screen ststus LED color
Power
consumption Return time
Input signals
Video Horizontal Vertical
ON Active Green Normal — ON ON ON
STAND-BY Black out Amber < 15Wat1s < 4sec. OFF OFF ON
SUSPEND Black out Amber < ISWatts < 4sec. OFF ON OFF
OFF Black out Amber < SWatts < 20sec. OFF OFF OFF
АРМ: Advartced Power Management
Caution
How to replace the system from the power management function.
1) Read the operation Manuals for the hardware you are using.
2) Press one of the (ffl
,Ш
,Я ,В ) keys on the front parwi.
The NO SIGNAL screen appears, and the monitor side power management function is
released (onty in OFF STATE).
^ Display Modes Memory )
This unit contains a microprocessor, arrd the user’s adjustments can be saved.
Up to 13 modes can be saved as the user’s preset tmdes.
If the new adjustmerTt data differs in any of the following four (4) ways, they can be saved
as new data.
Ног izontal
t raquency
Horizontal
synchronIzatIon
polarity
Vert leal
r requency
Vert leal
synchronizatIon
polarity
Note: In order for the new data to be saved, they must differ by more than the following error
ranges of the standard frequency ranges: 30kHz± 0.2kHz to 70kHz± 0.3kHz lor the
horizontal frequency and 50Hz± 0.3Hz to 180Hz± 1.2Hz for the vertical frequency.
* The data that can be saved are those in the following table.
Horizontal frec^jerK;y
Horizontal synchronization
polarity
Horizontal size Horizontal position
Vertical frequency
Vertical synchronization
polarity
Vertical size Vertical position
Pincushion distortion Video signal level Trapezoidal distortion Parallelogram distortion
How to saved adjustment data
О Input the computer signal to be
saved to the display unit.
Select the Item to be adjusted
from the OSD screen and then
adjust It.
When the ESC icon selected to
exit, the adjusted value is saved.
automatic memory
D>
It a front panel key Is not
operated tor about 10 seconds,
the adjustment Is saved.
There are 13 modes that can be preset by the user; if all 13 modes have already been
saved, when the one that has been saved last is deleted a ryew mode can be saved.
If the timing of the newly set data differs little in frequency from the previously saved timing
and in addition the signal polarity is the same,'they wilt be judged to be the same and the
new timing cannot be saved.
—
15
—