0+rotation, N a q o ^ (sino?<0 escg, Soaoi – Panasonic PanaSync Manuel d'utilisation
Page 19: Esc exit, Note, N a q o, Exit
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
0+ROTATION
H:70.2kHz V:165.5Hz
S3 ÍÍC- C3> El 0 CD
^ n a Q O ^
(Sino?<0 Escg
ROTATION
soaoi
DOB
This control adjusts the eveness of the screen image
relative to a horizontai iine.
□ « □
a Adjust key tilts the
screen image left.
B Adjust key tilts the
screen image right.
If theSor Badjust keys are pressed at the same time, the standard level will be set.
ESC
EXIT
H:70.2kHz V:165.5Hz
S3 iii- [3> B 0 m
O n a a O M
EIН30?Н ьt
a B1 EXIT
Press the a or B adjust keys to exit, and the OSD
menu is turned OFF.
Note;
1) Once two (2) of following tour (4) keys are pressed at the same time, the priority
order (from highest 1. to lowest 4. will be in the fotlowirig order:
1.S Select key 2.a Adjust key 3.B Adjust key 4.S Select key
2) If your monitor has no video signal (LED is green or amber) or no power (LED is dark)
when you are using your monitor and it was turned on, the monitor may have been
shut down by the Automatic Protection Circuit (APC). The procedure to reset the
APC is to turn the monitor OFF by pressing the Power Switch once, pause about ten
(10) seconds and then turn the monitor back on by pressing the Power Switch once
again.
— 14 —