Panasonic SC-HT280 - Manuel (Page 37)

Reference for speakers
Using other speakers
Connections to the FRONT B and SUBWOOFER OUT terminals
SUBWOOFER OUT
A subwoofer (not included)
with built-in amplifier can be
connected.
“B” terminais
For connection to a second pair of speakers.
Use the A terminals to enjoy Dolby Digital,
Dolby Pro Logic, DTS and SFC.
Replacing the speakers
You can use other speakers with this unit instead of the included set. The included speaker stickers come in useful if you decide to do this
pages 14-15).
When choosing replacement speakers, ensure they meet the following impedance ratings.
Front A or B 4-8 Q
A and B 8 Q
Center 8 Q
Surround 8 n
Subwoofer 6 n
After you have replaced the speakers, you may need to change the speaker settings on this unit pages 38-39).
Q)
O
C
a>
cc
c o
o
Si
o
S
QC
For front speakers with an impedance under 8 Q
SPEAKERS A, B
® ® ® © 0 ® ©
.. J
A SPEAKERS 6
1—SETTING-
o T lowim ?:
Press and hold [A] or [B] until “LOW IMP”
lights up on the display.
If even one of the speakers being used has an impedance under
8 ii, press and hold down either [A] or [B] for 4 seconds or more to
set the impedance on the main unit to LOW.
(Press and hold down once again lor 4 seconds or more to turn it
off.)
Note that when “LOW IMP” is illuminated, SPEAKERS A and B
cannot both be used at the same time.
To change speakers;
e.g. To use SPEAKERS B, press [A] ("H” goes out), and then
press [B] to activate SPEAKERS B.
iSHa
No settings are necessary when using the speakers included with
this unit. Settings may need to be changed if you replace the
speakers.
RQT5307