Panasonic PanaSync E50 - Manuel (Page 11)

To adjust the monitor image press the "Select" button to chose the desired display control func­
tion arxi press the '+" o r b u t t o n s to make your adjustment.
The monitor will save the adjustment values after function LED is extinguished. The monitor
will then store the saved values in one of the User Memories (See Page 11).
Front panel controls
OPERATIONS
® POWER Switch Push once to turn the Power On arxl once again to turn the
power Off.
(D Power/DPMS
Indicator
CD
The Power LED lights green when the power in On.
The Power LED will turn Amber when the Display Power
Management System is active (See Page 10).
The Power Switch is dark when the monitor is O f f .
(3) Degauss button
P(
Push this button is to demagnetize the CRT it the display
color is abnormal (See Page 14).
(2)"+" & (D
buttons
+ & -
Pressing " + " button for incressing or button for
decreasing the selected control function level.
Select button
SELECT
Used to select the desired display control function to be
adjusted. A LED is below each of the respective control func­
tion icons and lights to indicate the currently selected item.
(2) H-width
O
LED lights when selected to irxficafe that you may adjust
the image width with the '+' o r b u t t o n s .
(8) H-position
CD)
LED lights when selected to indicate that you may move
picture image toward left or right with the '+’ or"-" buttons.
(9) V-size
C3D
LED lights when selected to indicate that you may adjust
image height with the "+" o r b u t t o n s .
@) V-position
Q
led lights when selected to indicate that you may adjust
the image up or down with the '+' o r " - " buttons.
$1) V-pincushion
O
LED lights when selected to indicate that you may adjust
the bowing in or bowing out of the image sides with the "+"
o r b u t t o n s .
® Trapezoid
O
When selected, both the H-width(2)and H-position(|)LEDs
light to indicate that you may correct trapezoid distortion
with the o r b u t t o n s .
@ Contrast knob Sets the image contrast levelwhich controls the image White
level.
@ Brightness konb Sets the inrtage brightness level which controls the inrtage
Black level.
Memory Recall
furction
pFtecal-|
You can recall the factory Preset or Reservation mode (See
Pages 11 & 12) by pressing both the & "-t-" buttons at
once for about 2~3 seconds.
Self-Test function
saECT
The Self-test function can be activated by pressing the
"SELECT" button if there is no video signal or the Power
Management System is active (Power LED is Amber).
— 9 —