Remote control unit basics, Battery replacement (remote control unit), Notes on batteries – Panasonic CQ-DPG550 Manuel d'utilisation
Page 15: Operating procedures, General, Power, Only for cq-dpg550euc)
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Remote Control Unit Basics
(Only for CQ-DPG550EUC)
Battery Replacement (Remote Control Unit)
Lithium battery
Rear view of remote
control
Position B
1. Remove the battery holder.
Pull the holder by the Position B while pushing Position A in the
direction indicated by the arrow.
2. Replace the battery.
Set a new battery properly with the (+) side up as illustrated.
3. Insert the battery holder.
Push in the holder to the full.
Notes on Batteries
Old batteries must be removed and disposed of immediately.
Battery Information:
• Designated Battery: Panasonic Lithium Battery (CR2025)
• Battery Life: 6 months with normal use (in normal room temperature)
Cautiori:
~
Improper use of batteries may cause overheating, explosion or ignition, resulting in injury or fire.
Battery leakage may cause damage to the unit._____________________________________________
Do not disassemble or short the batteries. Do not throw the batteries into a fire.
To avoid the risk of accident, keep the batteries out of reach of children.
Battery holder Position A
©Power Button
©ATT Button
©Volume Control Button
@SEL Button
(DTUNEn'RACK UP/DOWN Button
©DISP Button
©BAND Button
®S»HDB Button
©Mode Button
Please refer Battery Replacement before using
remote control.
Operating Procedures
Aim the remote controller toward the sensor of
the main unit.
General
r
Power
©POWER (Power Button)
Press PWR to switch on the power.
Press PWR again to switch off the power.
SEL
@SEL (SEL Button)
--------------------------------- .
Press SEL to switch the audio mode in
the following order.
VOLUME « BASS ^
TREBLE
t
4
SUB m FADER
BALANCE
\_____________________
J
CQ-DPG550/DPG500EUC
15