Thetford N84 Series Installation Manual - Current - Manuel (Page 8)

Installation Manual 8
- If the depth of the enclosure is more than 26 inches, install a wood or an aluminum or galvanized sheet solid box baffle [21] in the
rear of the enclosure (See Art01617 and Art01618).
- Make sure that the bottom of the solid box baffle is 18 inches to 18 1/2 inches above the bottom of the enclosure [17] (4 1/4
inches to 4 3/4 inches above the top of the lower intake vent opening REF) [18].
- Make sure that the back of the solid box baffle is perpendicular to the bottom of the enclosure.
- Make sure that the back of the solid box baffle is either against the top of the enclosure or against the angled baffle [13]
(depending on the vehicle design).
- Make sure that the solid box baffle is one inch or less [19] from the coils [10] and condenser of the refrigerator.
- Make sure that the solid box baffle is the full width of the inside of the enclosure.
- If the design of the vehicle does not allow you to install a roof exhaust vent, install an upper side-wall exhaust vent.
The refrigerator is 23.7 in. min. to 24.0 in. max. from the rear of the breaker to the rear of the condenser [22].
N62X, N62XXX, N64X, N64XXX, N64XIM, and N64XIMXX models are 47.1 in. min. to 47.4 in. max. from the bottom
of the refrigerator to the bottom of the refrigerator condenser [23].
N82X, N82XXX, N84X, N84XXX, N84XIM, and N84XIMXX models are 54.1 in. min. to 54.4 in. max. from the bottom
of the refrigerator to the bottom of the refrigerator condenser [23] (See Art01601).
Art01617
14
15 13
12
19
11
21
18
17
10
9
Art01618
14 20
12
13
11
19
21
18
17
10
9
NOTICE