Troubleshooting, Specifications, There's no sound – Sony CDP-CA70ES Manuel d'utilisation
Page 21: The cd does not play, The remote does not function, The player functions incorrectly, Supplied accessories, Troubleshooting specifications, Additional information
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Additional Information
Troubleshooting
Specifications
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
^Check that the player is connected securely.
■♦Make sure you operate the amplifier correctly.
^Adjust the output level using the LINE OUT
LEVEL +/- buttons on the remote.
The CD does not play.
^There's no CD inside the player ("-NO DISC-"
appears). Insert a CD.
■►Place the CD with the label side up on the disc
tray correctly.
■♦Clean the CD (see page 20).
^Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 20).
^Place the CD in the correct position on the disc
tray.
The remote does not function.
■♦Remove the obstacles in the path of the remote
and the player.
^Point the remote at the remote sensor B on the
player.
^Replace all the batteries in the remote with new
ones if they are weak.
^Set the CD 1/2/3 switch on the remote
according to the position of the COMMAND
MODE selector at the rear panel of the player.
The player functions incorrectly.
^The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Compact disc player
Laser
Laser output
Frequency response
Signal-to-noise ratio
Dynamic range
Harmonic distortion
Channel separation
Semiconductor laser
(K
= 780 nm)
Emission duration; continuous
Max 44.6 pW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz ±0.3 dB
More than 117 dB
More than 99 dB
Less than 0.0025%
More than 110 dB
Output
Jack
type
Maximum
output
level
Load
impedance
LINE OUT
Phono
2V
Over 10 kilohms
jacks
(at 50 kilohms)
DIGITAL OUT
Optical
-18 dBm
Wave length: 660 nm
(OPTICAL)
output
connector
PHONES
Stereo
15 mW
32 ohms
phone jack
General
Power requirements
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
120 V AC 60 Hz
15 W
430 X 125 X 400 mm
(17
X
5
X
15 3/4 in.) incl. projecting
parts
7.0 kg (15 lbs 7 oz)
Supplied accessories
Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (1)
Size AA (R6) batteries (2)
Design and specifications are subject to change without notice.
21
US