Speaker placement, Note, Front speaker, center speaker, or rear speaker – Sony DVP-S500D Manuel d'utilisation
Page 38: Sub woofer, Notes, Specifying the speaker type, Speaker set up, Dolby digital surround
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Dolby Digital Surround
Speaker Placement
For the best possible surround sound, we recommend
the following conditions.
• Use higher performance speakers.
• Use rear and center speakers that match your front
speakers in size and performance.
• All speakers should be the same distance from the
listening position.
• Place the subwoofer between the front (L, R)
speakers if possible.
Note
Do not place the center or rear speakers farther away from the
listening position than the front speakers.
Speaker Set Up
To obtain the best possible surround sound, first
specify the type of speakers you have connected and
their distance from your listening position. Then use
the test tone to adjust the speaker volumes to the same
level.
ENTER
■ Front speaker, Center speaker, or Rear speaker
Normally select this symbol. This is default
setting.
A When the sound cracks or the effects of the
surround is difficult to hear, select this symbol.
This activates the Dolby Digital (AC-3) bass
redirection circuitry and outputs the bass
frequencies of the speaker from some other
speakers .
,-A If you will not connect the speaker, select this
symbol. You cannot select this symbol for the
front speakers.
■
Sub woofer
1^ If you connect a sub woofer, select this symbol
to output the LFE (low frequency effects)
channel from the sub woofer. This is default
setting.
iji, i If you do not connect a sub woofer, select this
symbol. This activates the Dolby Digital (AC-3)
bass redirection circuitry and outputs the LFE
signals from other speakers.
Notes
• The cut off frequency for the subwoofer is fixed at lOOHz.
• Set the subwoofer's cut off frequency as high as possible.
• Depending on the settings of other speakers, the subwoofer
may output excessive sound.
Specifying the speaker type
1
Press SET UP and select
"i#i 1
", then press ENTER.
2
Select the speaker you want to adjust in
"SPEAKER SETUP" and press ENTER.
3
Select the appropriate symbol for the speaker, then
press ENTER.
38
EN
5. 1 OUTPUT SETUP 1
SPEAKER SETUP
I
DISTANCE^^^
■Ш
NT
TEA
AR
0000 * HÈffl
1 2 f t
1 2 f t
1 0 f t
QUIT
3. 7m
3. 7m
3. Om
Symbol
Note
When you select a symbol, the sound cuts off for a moment.