Tweco 100XL Plus CE PAK Master - Manuel (Page 16)

INTRODUCTION 2-2 Manual 0-2813
7. Cut Capacity (Mild Steel)
Production: 1 inch (25.4 mm)
Severance: 1-1/4 inch (31.8 mm) severance
8. Pilot Circuitry
Capacitive Discharge (CD), Pulsed DC
9. Weight
75 lbs ( 34 kg) with work lead
82 lbs ( 37.2 kg) with work lead, torch & lead
10. Overall Dimensions
19" (482 mm) High x 10.5" (267 mm) Wide x 24.8"
(630 mm) Long
Overall dimensions are with Handle, Gas Regulator/Filter
Assembly and Two Stage Air Filter installed.
B. Gas Regulator/Filter Assembly
Specifications
The following specifications apply to the Gas Regulator/
Filter Assembly only:
1. Gas regulator maximum gauge pressure
160 psi (11 bar)
2. Maximum input gas pressure
125 psi (8.6 bar)
3. Filter
Coalescent type filter
C. Two Stage Air Line Filter Specifications
The following specifications apply to the Two Stage Air
Line Filter Assembly only:
NOTE
The two stage air line filter is for use on systems
using compressed air.
1. Air Flow
15 scfm (425 lpm)
NOTE
Depending on the moisture in the air source the
weep drain on the bottom of the Filter should be
left open 1/4 turn at all times. The weep drain will
allow 10 scfh (10.7 lpm) of air to escape using 100
psi line pressure in the closed position. This will
allow water, oil and contamination to escape from
the filter.
2. Maximum input pressure
250 psi (17.2 bar)
3. Dew Point
10° to 35° F (-12° to 1.7° C) @ Atmospheric Pressure
4. Filtration
5 micron
2.04 Power Supply Options and
Accessories
The following accessories are available for this power
supply. Refer to Section 6, Parts Lists, for part numbers
and ordering information.
A. Single-Stage Filter Kit
An optional in-line filter for use on compressed air
shop systems. Highly effective at removing moisture and
particulate matter from the air stream to at least 0.85 mi-
crons.
B. High Pressure Regulators
High pressure regulators are available. The regulators are
used to set the proper compressed air pressure.
C. Computer Control Cable (CNC)
The interface cable is available in two lengths, 25 ft
(7.6 m) and 50 ft (15.2 m). The cable is used to inter-
face the power supply with an auxiliary control de-
vice to provide OK-To-Move, ON/OFF signals and
standoff control signals.
D. Multi-Purpose Cart
Rugged steel cart on easy-rolling rear wheels and
front-mounted swivel casters. Provides maximum
mobility for the power supply and can also serve as
a display cart. Top shelf is 12 " (305 mm) x 20 (508
mm). Steel handle is 30" (762 mm) high.