Tweco 100 Auto-Cut - Manuel (Page 35)

Manual 0-4764 3-11 INSTALLATION
3.08 Connect Gas Supply Lines
1. Connect the gas supply lines to the appropriate input ports as shown.
RETURN SUPPLY
RETURN SUPPLY
Art # A-04844
Plasma Gas - In
Shield Gas - In
Water - In
3.09 Connect CNC Cable
1. Connect one end of the CNC cable to the power supply receptacle marked ‘CNC’.
2. Connect the other end of the cable to the CNC device .
3. The CNC cable shield must be attached to ground.
RETURN SUPPLY
RETURN SUPPLY
Art # A-04829
To CNC
NOTE
The CNC Cable shield must be grounded. See Illustration for further CNC cable wiring details.