Swiss+Tech Micro-Light Ultra - Manuel

Metal
Ring
Screws
Back Cover
LED Bulb
CR1616 Battery
CR1616 Battery
Transparent PVC Tube
Black Button
Top Cover
(notch)
(notch)
+
-
To turn flashlight on, squeeze and hold
button. Release to turn off. 11. Gently place the Battery/LED Bulb Assembly
back into the Top Cover with the LED Bulb
leads passing through the notch in the Top
Cover.
12. Holding the Top Cover, place the Metal Ring
in place with the LED Bulb protruding through
the opening in the Metal Ring.
13. Replace Bottom Cover and align screw holes.
14. Using a small Phillips screwdriver, gently turn
the three screws clockwise until tight.
1. Using a small Phillips screwdriver, remove the
three screws on the Back Cover.
2. Place the loose screws in a safe place.
3. Gently lift the Back Cover off to expose the
batteries and LED Bulb.
4. Lift the Metal Ring off.
5. Holding the Top Cover, gently push the Black
Button to lift the Battery/LED Bulb Assembly
out of the Top Cover.
6. Remove the Black Button and the LED Bulb.
7. Lift the two batteries out.
8. Replace with two new CR1616 or equivalent
Lithium button cell batteries. Stack the
batteries on top of each other,
positive (+) side up.
9. Position LED Bulb with the negative (-) lead
(with Transparent PVC Tube) underneath the
bottom battery (negative), and the other bulb
lead on top of the upper battery (positive).
10. Position Black Button under the bottom of the
Battery/LED Bulb Assembly with the notch in
the Black Button facing the LED Bulb.
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty to the
original purchaser in that this product is free from defects
in workmanship and materials. During the warranty period,
this product will either be repaired or replaced with a product
of equal or greater value, excluding any custom engraving
or printing.
Damage through normal wear and tear (including battery
expiration and surface coatings), repair or alteration, misuse,
abuse, neglect, accident, improper storage and handling, fire,
negligence, improper cleaning, circumstances not directly
attributable to manufacturing defects, or act of God is not
included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO,
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR USE.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. Simply return
your SWISS+TECH
® brand product postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139
Made in China. SWISS+TECH ® is a registered trademark and
First In Key Ring Products™ is a trademark of Swiss+Tech
Products. Specifications are subject to change without notice.
©2010 Swiss+Tech Products, Solon, OH 44139
www.swisstechtools.com
800-414-8799
First in Key Ring Products ™
ST74037
• DO NOT dispose of batteries in fire, batteries
may explode or leak.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries.
• REMOVE BATTERIES from equipment which is
not to be used for an extended period of time.
BATTERY WARNINGS:
Micro-Light Ultra
Instructions
Battery Replacement