Swiss+Tech Micro-Light Ice Manuel d'utilisation
Micro-light ice, Battery warnings, Battery replacement

Made in China. Micro-Light Ice™,
MMMMMMMMI
™
and
MI
™ are trademarks of Swiss+Tech Products.
Specifications are subject to change without notice.
©2012 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH
®
brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
www.swisstechtools.com
1-800-414-8799
ST74125
Micro-Light Ice
™
ON/OFF Button
Battery Replacement
1. Position your thumbnails as shown and pry
down the silicone housing (A).
2. Remove the old batteries.
3. Replace with two new CR1616 3V lithium
batteries or equivalent between bulb wires
with positive (+) side up.
4. Gently slide silicone housing onto bulb end
(B) with power button symbol (C) positioned
over bulb wires and work back into place.
• Super-bright white LED light
• Soft-squeeze ON/OFF button
• Silicone housing creates luminescent glow
• 100,000+ hour LED bulb
• Comes in a variety of attractive colors. Makes
a great gift to brighten up somebody's day!
A
Two CR1616
Batteries
Positive Side
(+) Up
Silicone
Housing
B
C