Swiss+Tech Pet Collar Light - Manuel

Made in China. MMMMMMMMI ™ and MI ™ are
trademarks of Swiss+Tech Products. Specifications
are subject to change without notice.
©2012 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH ® brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
www.swisstechtools.com
1-800-414-8799
ST74100
Pet Collar Light
Battery Replacement
1. Loosen captive screws (screws stay in
place to prevent loss). Remove back.
2. Remove old batteries.
3. Replace with two new CR1025 3V lithium
batteries or equivalent. Insert one with the
positive (+) side up, insert the other with
the positive side down.
4. Replace back. Tighten screws gently.
Slide
trimmed
Velcro
through slot
and wrap
Velcro around
pet collar.
Easy to Attach
• Use scissors to trim the velcro to the
length you need and strap the light to
your pet’s collar
Easy to Use
• Press the bulb once to turn ON
• Press the bulb a second time to activate
the FLASHER
• Press the bulb once more to turn OFF
Pull tab before use!
CR1025
Batteries
Press
Bulb
To
Turn
ON
Captive Screws
Positive
Side Up (+)
Positive
Side Down
Fun and Functional
• Make your pet visible in the dark
• Provides additional light while walking
• Choose steady or flashing light
• Works on any
size pet