Swiss+Tech Motion Sensor Light - Manuel

LED Motion
Sensor Light
AAA Batteries (3)
Battery Cover
• Motion Activated
• Automatic Shutoff after 90 seconds
of no motion
ATTACHES ANYWHERE!
• Cabinet
• Closet
• Cupboard
INSTALLATION
Peel off adhesive backing (A), press firmly onto
clean, dry surface. Allow 24 hours for adhesive
to set before using hook-and-loop fastener (B).
BATTERY REPLACEMENT
• Using a small Phillips screwdriver, loosen
the battery cover screws on the back of your
LED Motion Sensor Light.
• Lift off the battery cover.
• Remove old batteries, replace with 3 new
AAA batteries, positioned as shown in the
battery compartment.
• Replace battery cover and tighten screw
gently. Be sure not to over tighten.
• Bathroom
• Locker
• Garage • Toolbox
• Car Trunk
ON/OFF
Button
Motion
Sensor
LED
Light
A
B
8" x 3" folds to 2" x 1.5"
English
Made in China. MMMMMMMMI ™ and MI ™ are
trademarks of Swiss+Tech Products. Specifications
are subject to change without notice.
©2013 Swiss+Tech Products, Solon, OH 44139 USA
ST74129
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERIES
For interior use only. Do not expose to water.
WARNING
1-800-414-8799
www.swisstechtools.com