Brother PQ1300 - Manuel (Page 12)

12
CONTENTS
Accessories
Names of
Parts
Before You
Begin
Changing
Needles and
Light Bulb
Threading
Stitch
Samples and Needle Chart
Changing
Presser Feet
Basic Sewing
Caring for
Your
Machine
Trouble Shooting
8
6 While holding the end of the thread,
step on the foot controller for a few
seconds. Once enough thread has
wound itself around the bobbin to hold
itself in place, release the foot
controller and trim the excess thread. 7 Stop winding when bobbin is full.
Take foot of foot controller. 8 Manually move bobbin stop back to
original position. 9 Cut thread and remove bobbin.
Bobbin Insertion
1 Lift slide plate (and open bobbin
door). 2 Put bobbin into the bobbin case.
✽ Run thread through thread notch and
under latch spring, so that a length of
about 10 centimeters is exposed.
3 Pull the latch lever of the bobbin case
out and push the bobbin case into the
shuttle race and release the latch lever.
✽ If the latch lever is not all the way on
the hook, it may fly off during sewing
and cause lower thread breakage.
4 Lower slide plate and close bobbin
door.
CAUTION – Moving parts –
To reduce risk of injury, switch off before servicing. Replace cover.
Bobbin Stop
Slide Plate
Bobbin Door
Latch Spring
Thread Notch
✽ Bobbin should be
positioned so it
winds to the left