Dascom 7010 User Guide - Manuel (Page 22)

2
Printer Operation
22
LED Functions
1 POWER LED
It lights up when printer power is turned
on. (green)
2 ERROR LED
This is lit or flashes when the printer is
in error status. (orange)
Table of Alarm and Error Indications
In addition to normal operating mode, when an abnormal condition is detected
in the printer, an alarm sounds and ERROR LED either lights up or flashes to
indicate the type of error. The LCD indicates the error message.
Normal Operating Mode
POWER ERROR
1
2
FEED
MENU
PAUSE STOP
Item ERROR LED LCD
Printing possible (no error) OFF On Line
Stop or Pause key on operation panel pressed OFF Pause
Head temperature - high temperature abnormality Flashing
Alarm
Head Hot
Head temperature - low temperature abnormality Flashing
Error
Head Cold
g n i h s a l F y ti l a m r o n b a e r u t a r e p m e t r o t o m F P
Alarm
PFMotor Hot
Fan motor malfunction Flashing
Error
Fan Lock
Cutter motor temperature abnormality Flashing
Alarm
Cutter Hot
g n i h s a l F n e p o d a e H
Error
Head Open
Paper end Flashing
Error
Paper End
Paper out (paper position undetectable) Flashing
Error
Paper Load
Paper jam Flashing
Error
Paper Jam
Head low resistance value abnormality Flashing
Alarm
Head Check
Ribbon end Flashing
Error
Ribbon End
Communication error (receiving buffer overrun) Flashing
Error
Serial Over Run
g n i h s a l F ) y ti r a p ( r o r r e n o it a c i n u m m o C
Error
Serial Parity
Communication error (framing) Flashing
Error
Serial Framing
g n i h s a l F n e p o r e v o C
Error
Cover Open
*Auto-cutter abnormality (foreign object etc.) Flashing
Error
Cutter Fail
**Rewinder full (7010R only) Flashing
Error
Rewinder Full
**Rewinder cover open (7010R only) Flashing
Error
Rewinder Open
g n i h s a l F ewind fail (7010R only) R * *
Error
Rewind Fail
g n i h s a l F Rewinder Hot (7010R only) * *
Alarm
Rewinder Hot
* Applicable only when using the optional auto cutter
** Applicable only with the rewinder version