Aquascape AquaJet (91014, 91015 & 91016) - Manuel (Page 5)

AQUAJET ™ PUMP SPECS
Model Number 1000 2700 5200
Item Number #91014 #91015 #91016
average Pond size recommendation 1200 us gallons 1300 us gallons 2000 us gallons
maximum Fountain Height (Daisy Fountain) up to 47” up to 62” up to 65”
motor type mag-Drive mag-Drive mag-Drive
Wattage 33 110 250
amperage .55 1.00 2.60
Power cord Length 25 ft 25 ft 25 ft
Discharge Hose Diameter with nozzle fountain heads with nozzle fountain heads with nozzle fountain heads
Discharge Hose Diameter on Diverter ½”, ¾” ½”, ¾” ½”, ¾”, 1”
Warranty 3 Year Limited 3 Year Limited 3 Year Limited
5
www.aquascapeinc.com | ☎ CAN 1-866-766-3426 | ☎ US 1-866-877-6637
tyPiCal inStallation in a Water feature
• Unpack the Diverter Valve
and thread the collar
clockwise directly onto
the pump discharge male
thread. Do not overtighten
or use any tools.
• The Diverter Valve has two
flow-control valves:
1) the accessory diverter
valve controls water flow
to any additional filters,
fountains or waterfalls
2) Side valve controls
water flow to attached
fountain head
• The side valve controls the fountain height, but the accessory
valve will also have an effect on the fountain’s height. As
more accessory flow is desired the amount of water flowing
to the fountain will diminish. Closing the accessory valve will
maximize flow to the fountain head.
• Thread the Riser Stem Base onto discharge. Riser
Stems can be added to the base stem as-desired
to increase the fountain height to the best level for
your water feature and to compensate for different
pond depths.
insert additional riser Stems and
lock into position
thread riser Stem base
onto discharge
• Install any one of the three fountain heads onto the top riser
by simply pressing it over the end of the riser. it is held in
place by friction.
• The AquaJet ™ pump is designed to be
submerged directly into the pond. if
using the Diverter Valve to send water
to any additional filters, fountains or
waterfalls, maximize pond circulation
by locating the AquaJet ™ pump as far
away as possible from the location
of the water entering back into the
water feature.