Aquascape 1-Disc Fogger (99571) - Manuel (Page 5)

5
2.2 Remote Receiver (Refer to Fig. 1)
• Place the moving switch of the receiver to “ON” so the fogger will generate fog normally.
Press the “MODE” button for 16 different light options.
• To adjust the fog volume, turn the receiver on and press “FOG VOLUME”.
• To turn the fogger off, turn the receiver’s switch to “OFF”.
• To generate fog normally, move the receiver’s switch to “FOG”. This will not affect the
fogger’s LED lights because this function is for “sleeping time”.
Lighting
On/Off
Fog
Volume
Lighting
Mode
On/Off
Switch
On/Off
Switch
Figure 2
Lighting
On/Off
Fog
Volume
2.3 Remote Emitter (Refer to Fig. 2)
• Place the receiver’s switch to “ON” and face it
towards yourself.
• Press the red power switch to turn the
fogger on/off.
• Press the lighting on/off button to turn the LED on/off.
• Press the “LIGHTING MODE” button to use the 16
different LED lighting effects.
• Press the “FOG VOLUME” button to adjust the volume of fog.
) Safety Precautions
• Do not scratch the surface of or place anything on the water level sensor.
• Do not move the unit or pull the cable when in use. For the best fog effect, don’t place
anything less than 10 cm above the surface of the fogger, such as cable, containers, etc.
If your finger is above the ceramic disc, the ultrasonic vibrations may hurt you. However,
this is not electric shock.
• Place the transformer in a clean place away from any moisture.
*For replacement parts contact your local Aquascape, Inc. supplier
4) Maintenance & Service
4.1 Cleaning the Disc
• Clean the ceramic disc and the surface of the fog maker with a soft cloth and clean water.
Do not touch or scratch the ceramic disc or the water lever sensor switch. Don’t use wash-
ing powder or detergents to clean any part of the fog maker.
• If the fogger does not generate fog after running for some time, make sure there is enough
water in the container.
4.2 Replacing the Disc
• After running for approx. 3000 hours, the mist will reduce and will need a new ceramic
disc. Please purchase a new ceramic disc & key from your local distributor, and refer to
Fig. #3.
• Unplug the unit, remove the fogger from water and wipe the surface.
• Insert the key provided (see Fig. 3) into the winding ring and unscrew counter clockwise.
• Remove the winding ring and old ceramic disc. The inside of the unit cavity must be
completely dry before the parts are installed.
• Be sure to reinstall with the correct side (not the black side) facing up.
Figure 3
Bottom
of Disc
Top
of Disc
Key
Winding Ring
Ceramic Disc
Sealing Washer
Fog Cavity
Rubber Tuck
LED Lamp
Water Level
Sensor Switch
Indicator
replacement Parts Item#
Replacement Disc Kit 99589
99571 1-Disc Fogger Instructions5 5 6/2/06 2:41:31 PM