Black & Decker CTO6305C - Manuel (Page 4)

6 7
How to use
This product is for household use only.
getting StArteD
• Remove packing materials and any stickers. Peel off clear protective film from
control panel.
• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all parts as instructed in CARe And CleAnIng.
• Select a location for the unit. leave some space between the back of the unit and
your wall to allow heat to flow without damaging cabinet and walls.
• Insert crumb tray underneath the bottom heating elements.
• Untie the cord and unwind it.
• Plug unit into electrical outlet. 0 00 shows on the digital
display (C).
important: During the first few minutes of use, you may
notice smoke and a slight odor. this is normal and is not a
cause for concern.
$ "65 *0/
THIS OVEN GETS HOT. WHEN
IN USE, ALWAYS USE OVEN
MITTS OR POT HOLDERS
WHEN TOUCHING ANY OUTER
OR INNER SURFACE OF THE
OVEN
tHiS OVen getS HOt.
WHen in uSe, ALWAYS uSe OVen mittS
Or POt HOLDerS WHen tOuCHing
AnY Outer Or inner SurFACe OF tHe
OVen.
CAutiOn
HeLPFuL inFOrmAtiOn ABOut YOur OVen
• You can change the temperature from ˚F to ˚C by pressing the ▲ and ▼ buttons
simultaneously.
• For your convenience, the unit always remembers the last selected setting unless
unplugged. You can change this setting before the oven begins preheating or
once it has reached the preset temperature and time.
• You cannot change the temperature or time during the preheat cycle. once the
set temperature is reached, you can then change the time at any time.
• If using convection bake, remember to lower the suggested temperature of
a recipe or package by 25˚F.
Caution: unit gets hot. neVer touch outer surfaces, including the glass door.
Always use oven mitt or pot holder.
Position 
Use upper slots
along oven walls.
Insert rack
using a rack-up
position.
Position 
Use lower slots
along oven walls.
Insert rack
using a rack-up
position.
Position 
Use upper slots
along oven walls.
Insert rack using
a rack-down
position.
Position 
Use lower slots
along oven walls.
Insert rack using a
rack-down position.
D
SLiDe rACk POSitiOnS
There are 4 possible positions for the slide racks. There is an upper and a lower
slot; the rack can also be inverted for 2 additional positions (D).
eng
Li
SH
C