Tether connector strap using the versa-tether, Warning – Britax Child Seat Manuel d'utilisation
Page 15
26
27
Because every vehicle model is different,
sometimes you cannot find a location to
properly anchor the tether. Use the tether
connector strap to assist in creating an
anchor point (Fig. D).
Find a fixed vehicle anchor point that is
1
bolted to the floor.
If you cannot find an acceptable location to
•
create an anchor point, contact the vehicle
manufacturer to identify a suitable tether connection point.
Route the strap around the fixed vehicle anchor point.
2
Take the metal D-ring and thread it through the webbing loop
3
on the other end of the strap (Fig. D).
Pull the metal D-ring all the way through until the strap is
4
tight.
Use the D-ring as an attachment point for the hook on the
5
tether strap.
NOTE : Store the tether connector strap in the tether pouch when not
in use.
Tether Connector Strap
Using the Versa-Tether
®
Consult your vehicle owner’s manual for
1
designated tether anchorage locations.
Locate the tether on the rear of the
2
child seat and remove the tether from
the pouch.
Place the tether up and over the child
3
seat back.
Install the child seat using the LUAS
4
or the vehicle belts according to the
instructions in this manual.
Tilt the tether release tab ; then pull to
5
fully extend the tether strap into a “V”
shape.
Locate the hook on the strap and
6
loosely attach the tether to the vehicle’s
designated tether anchor.
See figure A for forward-facing installation.
•
See figures B and C for rear-facing
•
installations.
Secure the child seat by a vehicle seat
7
belt OR with the LCS connectors.
Pull the tether adjuster strap to remove
8
all slack. Roll up excess webbing and
store in tether pouch.
Verify there is tension in the tether
9
strap and that the child seat is properly
secured.
The child seat is secure when it cannot be moved front-to-back or side-to-
•
side more than 2.5 cm (1 inch) at the belt path.
Installation : Versa-Tether
®
Installation : Versa-Tether
®
d
OR
A
OR
b
c
WARNING!
Only use tether connector strap for rear-
facing tether installation.