Britax Child Seat - Manuel (Page 13)

22 23
Attach the Versa-Tether 6 ® hook to the designated tether anchor
for the chosen seating position. Remove all slack from the
tether to secure. Store excess webbing in the tether pouch. See
pages 25 – 27.
Verify that the vehicle belt is tight, locked, and child seat is 7
secure.
The child seat is secure when it cannot be moved front-to-back or side- •
to-side more than 2.5 cm (1 inch) at the belt path. If the child seat is not
secure, repeat the procedure or use an alternate seating location.
Lap-Belt Installation
Figure A illustrates a typical forward-facing, lap- •
belt installation.
When not in use, always store the LCS connectors •
in storage slots. See page 28.
Place the child seat forward-facing on the 1
vehicle seat. Ensure the bottom of the child
seat base is in full contact with the vehicle
seat.
Remove the Versa-Tether from the pouch 2
and place it up and over the child seat back.
Pull the vehicle belt out, then pass it through the forward-facing 3
belt path to the opposite side of the child seat (Fig. B).
Verify that the vehicle belt is not twisted, then buckle (Fig. C). 4
Push the child seat firmly into vehicle seat while tightening the 5
vehicle belt.
Installation : Forward-Facing Installation : Forward-Facing
b
c
A
Forward-facing
WARNING!
This child seat must NOT be used forward- •
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
This child seat must be in full upright position •
when installed forward-facing.
Always use the Versa-Tether when the child •
seat is installed forward-facing. Check your
vehicle owner’s manual for approved tether
anchor locations.