Trademark Tools Wall Mount Electric Fire Place with Remote Control - Manuel (Page 6)

6
Important Safety Instructions
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ
CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Remote Operation
The standby switch located at the top right hand side of the fire must be first switch on.
It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more than
once within two seconds for correct operation.
Press the button ON/OFF once on the remote control this turns ON/OFF the appliance and fire effect.
Press the 750W button once for the low heat settings; press twice to switch off the heat setting.
Press the 1500W button once for the high heat settings; press twice to switch off the heat setting.
Press the DIMMER button for operate the dimmer mode.
WARNING! Keep batteries away from children. If swallowed, seek medical attention immediately.
WARNING! Do not install battery backwards, charge, put in fire or mix with used or other battery
types — may explode or leak causing injury.
RECYCLE Battery must be recycled or disposed of properly. Check with your local authority or retailer for
recycling advice in your area.
Note: Make sure your batteries are fully charged and installed correctly in your remote control.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. Due to blocked air
vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes. Reconnect
the supply to the mains and switch on the appliance.
Troubleshooting
Symptom > Solution
No operation/no fan > Check for safety cut-off operation
No fire effect light > Check the bulb by replacement
Replacing the Lamp
WARNING! Always disconnect from the power supply before removing bulb.
WARNING! The bulbs reach high temperatures during operation. Allow the bulbs to cool down after
switching off the appliance before changing lamps.
Note: Two people will be required for this process.
It is recommended that the fire is carefully removed from the wall and laid on its back in order to replace
the lamp.
Gently slide the front glass panel towards the top of the fire and remove. Store the glass safely out of the
way whilst the bulb is replaced so that it does not get damaged.
At the bottom of fire, there is a lamp cover fixed by four Philip’s head screws — see Fig.5, remove the four