Trademark Tools Wall Mount Electric Fire Place with Remote Control - Manuel (Page 5)

5
Important Safety Instructions
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ
CAREFULLY AND RETAINED FOR FUTURE REFERENCE
the heater. The appliance is not designed to be installed in a recess.
A height of 600mm from bottom of heater to floor is recommended for optimum viewing of fuel
bed — see Fig.2 for recommends fixing dimensions.
Keep top of heater at least 1000mm away from ceiling or other objects for optimum heat ventilation.
For optimum viewing, mark the top four screws fixing positions on wall in accordance with the
recommend fixing dimensions — see Fig.2. Drill holes with a six drill bit.
WARNING! Never place this fireplace where it may fall into a bathtub or other water container.
WARNING! Ensure the power cord is not installed so that it is pinched against a sharp edge.
CAUTION! The fireplace must be mounted at two (2) pints, one of which must be a wall stud.
CAUTION! Ensure method of installation does not obscure the air intake slots of the unit.
Fix the wall bracket using that the plug and screws provided .
Carefully lift the heater up ensuring that the top rear ledge of heater engages the wall bracket (see Fig.2
in circle) and is sitting centrally.
Gently bring the heater level with the wall.
Mark the bottom holes position — see Fig.3, remove the heater ensuring that the bottom fixing bracket
is rotated up.
Drill and fit wall plug.
Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down again and use the
screw provided to permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the desired position.
Place the front glass surround over the front of the fire aligning the slots in the brackets at each side of
the glass panel with the lugs on the sides of the fire — see Fig.4. Again two people will be required for
this operation.
Instructions for Use
The appliance can be operated either by the switches located on the top right hand side of the fire or by
supplied remote control.
Manual Operation
The switches located at the top right hand side of the fire .The standby switch must be first switch on.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will appear to
indicate that the function is ON. Press the O/I button for 3 seconds this will operate the dimmer mode.
Press the 750W button once for the low heat settings; press twice to switch off the heat setting.
Press the 1500W button once for the high heat settings; press twice to switch off the heat setting.