Sunlite WM25M1X6- Manuel d'utilisation
Dispositifs optiques Sunlite

Important Safety InStructIonS - Save theSe InStructIonS
uSe only wIth claSS 2 power unIt
• These products are only suitable for connection to a Class 2 power
source and have not been evaluated for use when connected to a
power source that does not comply with Class 2 voltage and energy
limited supplies.
all InStallatIonS of SunStar25 Should be
performed by a certIfIed electrIcIan and be In
complIance wIth the natIonal electrIcIanS code aS
well aS local codeS.
SuItable for wet locatIonS
M
odel
M
ax
I
nput
V
oltage
(V
dc
)
M
ax
c
urrent
(
M
a)
M
ax
W
attage
WM25
24
700
8
F
Ixture
W
IrIng
:
Suggested wiring utilizes bullet connections in alignment with the direction of current flow from the driver.
WM25
T
o
P
oWer
S
uPPly
T
o
P
oWer
S
uPPly
T
o
S
erieS
F
ixTure
WM25
WM25
r(+)
B(-)
r(+)
B(-)
r(+)
B(-)
Drill hole in wall. Make
sure the hole is large
enough to move wires
through.
Retrieve wires from wall
and outfit with bullet
connections.
• Red (+) with a female
bullet connector.
• Black (-) with a male
bullet connector.
Outfit fixture wires with
bullet connections and
connect with the wires from
wall.
1
2
3
4
F
Ixture
I
nstallatIon
I
nstructIons
:
Push wires back into wall
and place fixture over
the hole. Insert screws to
secure the fixture to the
wall. Move the fixture to
point light in the desired
direction.
turn power off before any InStallatIon, InSpectIon or removal of fIxture/wIrIng.
conSIgneS de SÉcurItÉ ImportanteS - conServeZ SoIgneuSement ceS InStructIonS
a utIlISer unIQuement avec une Source d’alImentatIon
de claSSe 2
• Ces produits doivent être branchés uniquement à une source
d’alimentation de classe 2 et n’ont pas été testés pour une utilisation
lors d’une connexion à une source d’énergie non conforme à la tension
de classe 2 et à l’approvisionnement en énergie limitées.
ce produIt doIt Étre InStallÉ Selon le code
d’InStallatIon pertInent, par une perSonne QuI connaÍt
bIen le produIt et Son fonctIonnement aInSI Que leS
rISQueS InhÉrentS.
convIent aux emplacementS mouIllÉS.
R (+)
B (-)
R (+)
B (-)
R (+)
B (-)
R (+)
B (-)
E464824
Solid State led
WM25
interior / exterior
Spot light
diMMing CapaBle
C
ErtifiCation
:
>0.9 Power Factor
700mA / ~10VDC
-30° C to 40°C
6.5W
E
nErgy
:
C
ontaCt
:
4811 Quail Crest Place
Lawrence, KS 66049
www.sunlitest.com
T:785.856.0219
UL and cUL
Damp Location Listed
IP64 Rated
Wall Mount 25 - “WM25” - loW Voltage Surface Mounted luMinaire