Sunlite SR50M2X6-WSEX - Manuel

Important Safety InStructIonS - Save theSe InStructIonS
uSe only wIth claSS 2 power unIt
• These products are only suitable for connection to a Class 2 power
source and have not been evaluated for use when connected to a
power source that does not comply with Class 2 voltage and energy
limited supplies.
all InStallatIonS of SunStar25 Should be
performed by a certIfIed electrIcIan and be In
complIance wIth the natIonal electrIcIanS code aS
well aS local codeS.
SuItable for wet locatIonS
M
odel
M
ax
I
nput
V
oltage
(V
dc
) M
ax
c
urrent
(
M
a) M
ax
W
attage
SR50-WSEX 24 1400 15
F
Ixture
W
IrIng
:
Suggested wiring utilizes bullet connections in alignment with the direction of current flow from the driver.
SR50
SR50
P oWER S uPPly
T o P oWER S uPPly
R(+)
R(+)
B(-)
B(-)
e338721
SolId State led
Sr50-WSex
InterIor / exterIor
wall Sconce
c
ertIFIcatIon
:
UL and cUL
Wet Location Listed
IP66 Rated
e
nergy
:
>0.9 Power Factor
700mA / ~ 20VDC
-30° C to 40°C
c
ontact
:
4811 Quail Crest Place
Lawrence, KS 66049
www.sunlitest.com
T:785.856.0219
R(+)
B(-)
R(+)
B(-)
Once single-gang box is completely installed, outfit the
exposed wires with bullet connections.
• Red (+) with a female bullet connector.
• Black (-) with a male bullet connector.
Outfit the fixture wires with bullet connections and then
connect bullet connections from fixture wires and driver
wires together.
1 2 3
F
Ixture
I
nStallatIon
I
nStructIonS
:
turn power off before any InStallatIon, InSpectIon or removal of fIxture/wIrIng.
SIngle-gang box, #8-32 hanger boltS, and acorn fInIShIng nutS are SupplIed by otherS.
SIngle-gang box Should be completely InStalled before attemptIng to InStall thIS fIxture.
Push wires back into wall and screw in acorn finishing
nuts over the hanger bolts to secure fixture on wall.
conSIgneS de SÉcurItÉ ImportanteS - conServeZ SoIgneuSement ceS InStructIonS
a utIlISer unIQuement avec une Source d’alImentatIon
de claSSe 2
• Ces produits doivent être branchés uniquement à une source
d’alimentation de classe 2 et n’ont pas été testés pour une utilisation
lors d’une connexion à une source d’énergie non conforme à la tension
de classe 2 et à l’approvisionnement en énergie limitées.
ce produIt doIt Étre InStallÉ Selon le code
d’InStallatIon pertInent, par une perSonne QuI connaÍt
bIen le produIt et Son fonctIonnement aInSI Que leS
rISQueS InhÉrentS.
convIent aux emplacementS mouIllÉS.
Wall Sconce 50 - SR50-WSeX” - loW Voltage SuRface Mounted luMinaiRe